Jack Hammer Adapter Compression Points The point is screwed into

The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap

( Remove The point after marking the pipe)

It is actually 3" in diameter and will make a hole large enough to accommodate a 2" Sch 40 pipe with a coupling

This part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole

Jack Hammer Adapter Compression Points The point is screwed intoThis part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole. It basically has 2 holes in it. One larger hole that will slide over the impact cap and one smaller hole that will recieve the sawed off blunted, 1 1 8" hex bit connected to the jackhammer. Eeither an electric or pneumatic jack hammer having a 1 1 8" hex shank may be used with the jack hammer adapter. NOTE: An Idea is to use an old. worn